Skip to main content

Unit information: Physics Project 333 in 2022/23

Please note: you are viewing unit and programme information for a past academic year. Please see the current academic year for up to date information.

Unit name Physics Project 333
Unit code PHYS39330
Credit points 30
Level of study H/6
Teaching block(s) Teaching Block 4 (weeks 1-24)
Unit director Professor. Carrington
Open unit status Not open
Units you must take before you take this one (pre-requisite units)

120 credit points at Level I/5 of any BSc single honours or joint honours Physics programme.

Units you must take alongside this one (co-requisite units)

None

Units you may not take alongside this one

.

School/department School of Physics
Faculty Faculty of Science

Unit Information

This project is an opportunity for students to take a topic in physics, either experimental or theoretical, and carry out an investigation, usually associated with one of the research areas in the department. Experimental projects are usually done in pairs. The project is student-led and leads to a substantial report detailing the project, how it was approached and the results obtained.

Aims:

The project is a substantial exercise where the student learns and demonstrates initiative and independence, bringing a diversity of knowledge and skills to bear on a particular topic. It is also intended that the student will gain insight into tackling real problems rather than simply acquisition of knowledge.

Your learning on this unit

The student will:

  • learn how to bring a diversity of knowledge and skills to bear on a specific problem,
  • learn how to identify skills and knowledge needed to carry a project forward and how to acquire them,
  • learn how to present material clearly and concisely both verbally and in manuscript,
  • produce a clear and coherent report representing a significant academic document about the topic.

How you will learn

Experimental projects are laboratory-based while theoretical projects will be library-based. Both involve a supervisor and an assessor, both of whom will be involved during the duration of the project. Generally the student and supervisor will meet weekly.

How you will be assessed

Assessment is through an interim presentation at the start of spring term and a final report or dissertation of about 6,000 words at the start of summer term. The interim presentation is 10 minutes long followed by 2 minutes of questions. The presentations are given individually, attended by an assessor and small group (typically 5-10) of other project or dissertation students. The presentation is jointly marked by the assessor and your peers. The final project report or dissertation must be produced independently, even if the work was done in pairs. The report or dissertation will be independently marked by an assessor and your supervisor, and you will have an approximately 30 minute interview to discuss your project or dissertation. The final assessment is based on day-to-day performance, the quality of the report, the results and analysis. Marks will be awarded for technical ability, diligence, motivation and an understanding of the science of the project or dissertation. The marks will be agreed upon by the assessor and supervisor.

The final unit mark is made up of two coursework components weighted as follows

Interim presentation (10%) Final project report or dissertation and interview (90%)

Resources

If this unit has a Resource List, you will normally find a link to it in the Blackboard area for the unit. Sometimes there will be a separate link for each weekly topic.

If you are unable to access a list through Blackboard, you can also find it via the Resource Lists homepage. Search for the list by the unit name or code (e.g. PHYS39330).

How much time the unit requires
Each credit equates to 10 hours of total student input. For example a 20 credit unit will take you 200 hours of study to complete. Your total learning time is made up of contact time, directed learning tasks, independent learning and assessment activity.

See the Faculty workload statement relating to this unit for more information.

Assessment
The Board of Examiners will consider all cases where students have failed or not completed the assessments required for credit. The Board considers each student's outcomes across all the units which contribute to each year's programme of study. If you have self-certificated your absence from an assessment, you will normally be required to complete it the next time it runs (this is usually in the next assessment period).
The Board of Examiners will take into account any extenuating circumstances and operates within the Regulations and Code of Practice for Taught Programmes.

Feedback