Unit name | Heat Transfer |
---|---|
Unit code | MENG31101 |
Credit points | 10 |
Level of study | H/6 |
Teaching block(s) |
Teaching Block 2 (weeks 13 - 24) |
Unit director | Dr. Becky Selwyn |
Open unit status | Not open |
Pre-requisites |
MENG20600 or equivalent |
Co-requisites |
None |
School/department | Department of Mechanical Engineering |
Faculty | Faculty of Engineering |
Heat Transfer is an advanced course which adopts a rigorous mathematical approach to the formulation and analysis of complex engineering problems in conduction, convection and radiation heat transfer. Students will be given an introduction to the Navier-Stokes, Continuity and Energy Equations, with emphasis placed on identifying the physical principles involved and the using relevant simplifications to find engineering solutions. Both analytic and computer-based solutions are explored. These studies are supplemented by a piece of coursework on the use of a computational software to solve a typical engineering problem, plus a wide range of worked examples, and problem sheets.
By the end of the course, students should be able to:
o Conduction in Cartesian, cylindrical or spherical coordinates with a range of boundary conditions
o Heat transfer from extended surfaces (fins)
o Convection in laminar flows over flat plates
o Convection in laminar flows through ducts or pipes
o Convection in high speed or turbulent flows
Simplify and solve equations for thermal radiation.
There are 3 hours of lecture per week over 12 weeks, a 2 hour written examination at the end of the year, and a piece of coursework which students are advised to spend no more than 10 hours working on.
A feedback session is held after submission of coursework to clarify common errors and highlight good practice
2 hour written examination (90%)
Coursework involving use of computational software (10%)